Game Cube No Disc Message

Author Topic: Game Cube No Disc Message  (Read 31517 times)

TheNeglected

  • Newbie
  • *
  • Posts: 2
  • Newcomer
Game Cube No Disc Message
« on: November 28, 2019, 07:15:17 AM »
My console for some reason fails to read any discs, showing a "No Disc" message when on the game play menu.

I have both tryed cleaning the lens with isopropyl alcohol on a q-tip and have adjusted the Pet on the back of the board to everywhere between 50 omns and 450 omns, although when i first checked it was pretty perfectly on 200 omns so i doubt that was ever the issue.

Opening it up there is no obvious damage to any boards or componenets and all the capacitors seem to be passing current. the laser appears to work (is emmitting light), and the laser carrage does move up and down on its own. The disc also spins, although sometimes it seems to need me to spin it a bit before it will speed up on its own (not sure if that means the motor is week or it just didnt need to spin to initally check for a disc in the drive)

I have a bit of an emotional attechment to the console and want to avoid replacing it if possible, and the repair guy near me would charge more that the console is actually worth, so i am trying to repair it myself but am stumped on what is actually wrong with the console.

I know this is a common issue but the common answers dont seem to workiong, does anyone have any suggestion on what to try / what the issue may be?

Bone Shark

  • Member
  • **
  • Posts: 22
  • Newcomer
Re: Game Cube No Disc Message
« Reply #1 on: November 28, 2019, 03:30:19 PM »

Sounds to me like a bad laser, but since you say you don't think it is, have you tried replacing the laser circuit board? By the way, the laser light comes on even on a trashed laser so you can't go by that. When the laser drive moves, does it move to the outer area of the disk rather quickly?

TheNeglected

  • Newbie
  • *
  • Posts: 2
  • Newcomer
Re: Game Cube No Disc Message
« Reply #2 on: November 28, 2019, 05:51:19 PM »
The laser appears to scan the center portion of the disc a bit, then move out and back in again, sometimes multiple times before giving up.

zincmann

  • Newbie
  • *
  • Posts: 3
  • Newcomer
Re: Game Cube No Disc Message
« Reply #3 on: December 05, 2019, 12:03:01 PM »
Try adjusting the laser pot like I did.  Quarter turn counter clockwise should do it, worked for me.